Polycom DOC2237A Uživatelský manuál stáhnout pdf (Strana 50)

Chapter 2 - Hardware Installation

2-30

Connecting the MGC-50 to the ATM Network

The MGC-50 can be connected to an ATM network. The type of connection

used differs according to the ATM Network Interface card installed in the

MCU.

If an ATM-25 network interface card is installed, connect the 8-pin

RJ-45 connector of the network cable to the NET RJ-45 jack on the rear panel

of the MGC.

Figure 2-15: ATM-25 network connection

If an ATM-155 network interface card is installed, first remove the rubber

plug covering the jack. Then connect the fiber optics cable connector to the

jack on the rear panel of the MGC.

Figure 2-16: ATM -155 network connection

ATM 155 t k

The ATM network properties must be defined in the Network Services, for

details, see the MGC Administrator’s Guide, Chapter 3.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 169 170

Žádné komentáře

Polycom DOC2237A Uživatelský manuál Strana 50