Polycom DOC2558B Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Počítače Polycom DOC2558B. Polycom DOC2558B User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - Hardware Guide

Polycom® RMX® 2000 SystemHardware Guide Version 7.0.1| September 2010 | DOC2558B

Strany 2 - Patent Information

Chapter 1- Hardware Description1-4Maximum number of Recording Links20 (default) 20 (default) 20 (default)Maximum number of IVR Video Slides150 150 150

Strany 3 - Regulatory Notices

Polycom RMX 2000 Hardware Guide1-5Resource CapacitiesThe following table summarizes the resource capacities for a fully loaded system per card typeTab

Strany 4

Chapter 1- Hardware Description1-6Site RequirementsThis section describes the requirements your site must meet for safe installation and operation of

Strany 5 - Table of Contents

Polycom RMX 2000 Hardware Guide1-7• In a single rack installation, stabilizers should be attached to the rack.• In multiple rack installations, the ra

Strany 6

Chapter 1- Hardware Description1-8RMX 2000 ComponentsOn the RMX 2000 components are located on both the front and rear of the MCU as listed in Table 1

Strany 7 - Hardware Description

Polycom RMX 2000 Hardware Guide1-9Table 1-4 Polycom RMX 2000 Component DescriptionComponent DescriptionCNTL (CPU) ModuleThe CNTL module controls and

Strany 8 - RMX 2000 Specifications

Chapter 1- Hardware Description1-10Multi Processor Module+ (MPM+) CardThe MPM+ cards, perform the various RTP, audio and video processing functions on

Strany 9 - RMX 2000 System Capacities

Polycom RMX 2000 Hardware Guide1-11RMX 2000 Rear PanelThe RMX 2000 rear panel contains the RTM IP card and optionally, the RTM ISDN card. The RTM IP c

Strany 10

Chapter 1- Hardware Description1-12The following items appear on the RMX 2000 rear panel:Table 1-5 RMX 2000 Rear Panel - RTM IP Component Description

Strany 11 - Resource Capacities

Polycom RMX 2000 Hardware Guide1-13RTM ISDNThe RTM ISDN card connects directly to an MPM/MPM+/MPMx. The RTM ISDN card routes data between the MPM/MPM+

Strany 12 - Site Requirements

Trademark InformationPolycom®, the Polycom “Triangles” logo, and the names and marks associated with Polycom’s products are trademarks and/or service

Strany 13 - Installation Precautions

Chapter 1- Hardware Description1-14Figure 1-3 RMX 2000 RTM ISDN Rear Panel LayoutISDN/PSTN Clock SourceEach RTM ISDN card has its own primary and seco

Strany 14 - RMX 2000 Components

Polycom RMX 2000 Hardware Guide1-15Cables Connected to the RTM IP & ISDN CardsAll external connectors are located on the rear panel.Figure 1-4 RMX

Strany 15 - • MPM - H - 13 DSP’s

Chapter 1- Hardware Description1-16RMX 2000 LEDsThe RMX includes LEDs located on the front panel and rear panel. In the front panel, the LEDs reflect

Strany 16

Polycom RMX 2000 Hardware Guide1-17MPM/MPM+ CardERR Red ON - Major error on card.Flashes - During card startup.RDY Green ON - The card has completed s

Strany 17 - RMX 2000 Rear Panel

Chapter 1- Hardware Description1-18CNTL Unit ERR Red ON - Major system error. In case of an active alarm this light is ON, and the RDY green is OFF.OF

Strany 18

Polycom RMX 2000 Hardware Guide1-19RMX 2000 Rear Panel LEDsRTM IPThe following LEDs appear on the RTM IP card:Table 1-7 RMX 2000 RTM IP LEDsComponent

Strany 19 - RTM ISDN

Chapter 1- Hardware Description1-20ShMG LEDs ERR Red ON - Major error on RTM card.Flashes - During system startup.ACT Red ON - Packet flow to and from

Strany 20 - ISDN/PSTN Clock Source

Polycom RMX 2000 Hardware Guide1-21RTM ISDNThe following LEDs appear on the RTM ISDN:Table 1-8 RMX 2000 RTM ISDN LEDsFunction NameLED NameLED Color D

Strany 21

Chapter 1- Hardware Description1-22MPM/MPM+ and MPMx Configuration ModesThe RMX unit can work with either MPM or MPM+/MPMx (but not with both simultan

Strany 22 - RMX 2000 LEDs

Polycom RMX 2000 Hardware Guide1-23MPM+ Resource Capacities per Card TypeThe MPM+ card offers increased resource capacities and capabilities. Three MP

Strany 23

Regulatory NoticesUnited States Federal Communication Commission (FCC)Part 15: Class A Statement. This equipment has been tested and found to comply w

Strany 24

Chapter 1- Hardware Description1-24MPMx Resource Capacities per Card AssemblyThe MPMx card offers increased resource capacities and capabilities. Two

Strany 25 - RMX 2000 Rear Panel LEDs

Polycom RMX 2000 Hardware Guide1-25Operating Mode Selection During Startup / RestartWhen started with Version 7.0 installed, the RMX enters MPMx Mode

Strany 26

Chapter 1- Hardware Description1-26Example 1:Current status• An RMX has two MPM cards installed.•The Card Configuration Mode is MPM. • Both MPM cards

Strany 27

Polycom RMX 2000 Hardware Guide1-27• The remaining MPM card is disabled.Example 2: Current status• An RMX has one MPMx card installed. •The Card Confi

Strany 28 - Applicable

Chapter 1- Hardware Description1-28RMX Chassis TypesThe RMX chassis can be of type A/B/C or D. The environmentally friendly D-type chassis (indicated

Strany 29

Polycom RMX 2000 Hardware Guide1-29Component ReplacementThe RMX 2000 is designed with ease of maintenance in mind. Most components are swappable and a

Strany 30

Chapter 1- Hardware Description1-30Types of Ejector Levers on RMX ComponentsOn the RMX, 2 types of ejector levers can be attached to the cards:• An al

Strany 31 - System Information Changes

Polycom RMX 2000 Hardware Guide1-31• Partially Open - For card powering down mode. Partially open the ejector lever(s) until the blue HS LEDs on the c

Strany 32

Chapter 1- Hardware Description1-325 On the CNTL Module to be installed, move the ejector lever to the fully open position.6 Slide in the replacement

Strany 33

Polycom RMX 2000 Hardware Guide1-33Replacing the Power Supply ModuleA single supply unit powers the RMX 2000. Use the following procedure to replace a

Strany 34 - RMX Chassis Types

Compliant with European Battery Directive 2006/66/ECTo comply with the European Battery Directive 2006/66/EC, dispose of weak and worn out batteries i

Strany 35 - Component Replacement

Chapter 1- Hardware Description1-34Replacing the Fan DrawerThree fans are mounted in the Fan drawer, where the airflow is from right to left. Should o

Strany 36 - Warning!

Polycom RMX 2000 Hardware Guide1-35Replacing a Faulty MPM/MPM+/MPMx CardRemoving the MPM/MPM+/MPMx Card from the MCUAll MPM/MPM+/MPMx cards can be ins

Strany 37 - Replacing the CNTL Module

Chapter 1- Hardware Description1-365 Carefully slide the MPM/MPM+/MPMx card out through the front panel.Installing the Replacement MPM/MPM+/MPMx Card1

Strany 38 - CNTL Module

Polycom RMX 2000 Hardware Guide1-37The blue HS LEDs on the MPM/MPM+/MPMx card and the Control Unit start flashing and the power on cycle for the card

Strany 39

Chapter 1- Hardware Description1-386 Slide in the replacement RTM ISDN card.7 Insert the card into the slot until the ejector levers touch the front e

Strany 40 - Replacing the Fan Drawer

Polycom RMX 2000 Hardware Guide1-39Replacing the RTM IP CardThe RTM IP card on the rear of the RMX 2000 provides connectivity to all the MCU modules.

Strany 41

Polycom RMX 2000 Hardware GuideiTable of ContentsHardware Description . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1Main Features ...

Strany 42 - RMX 2000

Table of ContentsiiReplacing the Fan Drawer ... 1-34Replacing a Faulty MPM/MPM+/MPMx Card ...

Strany 43 - Replacing a RTM ISDN Card

1Hardware DescriptionThis Hardware Guide provides information on the RMX 2000 and its components. This system utilizes a modular “universal slot” plat

Strany 44 - PRI Cables

Chapter 1- Hardware Description1-2RMX 2000 SpecificationsTable 1-1 Polycom RMX 2000 SpecificationsPhysicalHeight 3U (13.25 cm.)Width 19” (48.26 cm.)D

Strany 45 - Replacing the RTM IP Card

Polycom RMX 2000 Hardware Guide1-3RMX 2000 System CapacitiesConferencing CapacitiesThe following table summarizes the different conferencing capacitie

Komentáře k této Příručce

Žádné komentáře